Durun lütfen yüklemiyor...


The valve is closed by reducing the disks

08:46, çarşamba, 05 ağustos, 2020
The valve is closed by reducing the disks

Gate valves are generally divided into 2 kinds: parallel and wedge-shaped.The parallel gate valve at this site utilizes a flat disc gate between two parallel seats, upstream and downstream. Shut-off is obtained with the free-floating seat or disk gate let the upstream pressure to seal the seat and disk against any Gate Valve image unwanted seat leakage. Some parallel gate valves are designed to let the seat for being spring-energized by an elastomer that applies constant pressure to your disk gate seating surface.

Various kinds of materials can be used for gate valve construction. Typical common materials used are cast carbon steel, certain, ductile iron, gunmetal, bronze, alloy steels, stainless, and forged steels. Brass and PVC gate valves bring plumbing services. The material selection for gate valves primarily will depend on fluid service and its particular design temperature. The following table comes with a typical illustration of common materials found in Gate valve construction.

In the double-disk parallel-seat type, the valve is closed by reducing the disks in the valve neck to some height comparable to that from the valve seats. Once so positioned, an inclined plane mounted involving the two disks converts downward stem force into axial force and presses the parallel disks firmly up against the valve seats sealing the 2 openings. These varieties of valve design can accommodate asymmetric or angularly misaligned valve seats. Parallel gate valves are utilized in low pressure drops and low pressures, and where tight shutoff just isn't an important prerequisite.

You must identify the operating temperature, i.e. the temperature with the circulating media, in addition to the ambient temperature about the valve body. It is important to have in mind the extreme temperatures the valve will need to undergo in order being able to select a valve meant to operate under these conditions, particularly with regard to your materials used in the manufacture on the body, the closure system as well as the sealing parts.

The operating pressure, i.e. pressure to succeed the media circulates at from the valve.The fluid flow rate plus the flow velocity. Flow rate and nominal speed are important elements that can assist you choose the appropriate valve, particularly if it is being used to control this flow rate. The flow factor (Kv) is often a theoretical value defined with the manufacturer that permits the nominal flow rate in the valve to become calculated. It can be indicated in liters each minute (l/min) maybe in cubic meters by the hour (m3/h) . Valve manufacturers offer charts to view this factor depending on the desired flow rate and nominal diameter.

To promote the post
Makaleyi yayınlamağı hakkında bilgiler veriyoruz, Basın sekreteri. Basın sekreteri projenin içinde
Abone ol ve malalelerin yayınla:
| | |
2769 | 0 | 0